Servo hps-aa702Futaba

Descrizione del prodotto : SERVO HPS-AA702

Replaces the HPS-AA701 servo. Same features but uses a new generation micro processor.
New FUTABA Servo for aircraft with metal gear.
New HPS brushless motor technology specially designed for more performance and better cooling. (SR compatible)

Technical characteristics:
- S.BUS2 high performance HPS digital servo
- Aluminum case
- Metal gear
- Brushless HPS motor
- High voltage
- Ball bearing (x2)
- Low wear potentiometer
- High resolution
- High feedback precision

With new HPS technology, energy consumption is lower over the entire operating time. Like any S.BUS2 servo, the HPS-AA701 can be connected to all conventional receivers with PWM modulation and can be optimally adapted to the respective application conditions by programming.

This servo can be programmed from different ways:
1. With the practical SBC-1 programmer
2. On the PC with the CIU-3 USB adapter
3. On the S.BUS connection of the transmitter
< br> The following parameters can be defined:

• S.BUS channel assignment

• Servo rotation direction

• Soft start (on / off)

• Mode selection in the event of a failure of the Hold or Free signal

• Smooth servo operation (on/off)

• servo position (servo tester)

• Servo center adjustment +/- 300 µs (approximately 30 degrees)

• Servo speed, 0.39 - 9 seconds per 45 degrees

• Setting the dead band (dead band)

• Adjusting the left and right servo travel separately, approximately 50 to 175%

• Starting power

• damping

• holding power

Features:
Dimensions: 40.5 x 21.0 x 39.4 mm
Power supply: 6V-7.4V
Weight: 44 g
Speed under 6.6V: 0.08s/60°
Speed under 7.4V: 0.075s/60°

Torque under 6.6V: 45 kg/cm
br> Torque under 7.4V: 49.0 kg/cm
Use: large-scale aircraft for example for ailerons!

---

---

---

Codice : 01006033